High quality carbide inserts supplier
Carbide is more expensive per unit than other typical tool materials, and it is more brittle, making it susceptible to chipping and breaking. To offset these problems, the carbide cutting tip itself is often in the form of a small insert for a larger tipped tool whose shank is made of another material, usually carbon tool steel. This gives the benefit of using carbide at the cutting interface without the high cost and brittleness of making the entire tool out of carbide. Most modern face mills use carbide inserts, as well as many rotary cutting tools and endmills.
Guhring’s interchangeable carbide inserts
Guhring‘s interchangeable carbide inserts are in respect of tool material, geometry and surface finish perfectly adapted to your specific range of application. Subsequently, you will always achieve optimal machining results with maximum performance and highest economic efficiency. The carbide insert change can be performed in the machining problem-free, the interchangeable insert always sits perfectly clamped and positioned in the holder. Our interchangeable carbide inserts range are:
- Carbide Inserts for Single Fluted Gun Drills EB800
- Interchangeable Carbide Inserts for HT800WP Drill
- Interchangeable Carbide Inserts for RT800 Drill
- Interchangeable Carbide Inserts for LT800 Drill
HT 800 WP – The Interchangeable Carbide Insert Drilling System Performance Video
The ideal drilling system for the production of large, highly-accurate holes in a variety of materials for wind and water power stations, engine plants or gas/steam turbines. With the new Carbide Insert, HT 800 WP interchangeable drilling system Guhring provides high-performance and cost-efficient holders for holes in the diameter range from 11.00 to 40.0 mm.
Extended tool life
Thanks to special, micro-machined cutting edges and the application oriented surface finish the interchangeable carbide inserts of the HT 800 WP drilling system are especially wear resistant.
The holders of the HT 800 WP drilling system also possess a very high wear resistance. This is based on the optimised holder material with nickel plated surface as well as incremental holder sizes in steps of 0.5 mm up to diameter 31.99 mm and in steps of 1.0 mm above diameter 32.00 mm. This leads to less wear on the holder body.
Carbide inserts are use for a power tool as setting to fit whatever is appropriate for the job, at the the time and they are used for cutting. They are used by mechanics for working on cars. They cost less than other tools used in this profession. These carbide inserts come in many sizes ranging from sizes 0.0 to 0.012 inches. The mechanic will determine what setting to fit the job he has to get done.
There are four carbide inserts below. Please select the one you need to view further information.
|Carbide Inserts for Single Fulted Gun Drills EB 800||Interchangeable Carbide Inserts for HT800WP Drill||Interchangeable Carbide Inserts for RT800 Drill||Interchangeable Carbide Inserts for LT800 Drill|